KR1S Rear Wheel Spindle Thread Pitch ???

headcoats · Post by **headcoats** » Tue Jan 22, 2013 9:16 pm

Any ideas chicklets

Luders · Post by **Luders** » Tue Jan 22, 2013 10:02 pm

I can measure one tomorrow Martin if no one knows off the top of their head. Might even be in the morning if I get up early enough, no working from home for me this week

KFOR · Post by **KFOR** » Tue Jan 22, 2013 10:30 pm

It's amazing how much I can get done in the garage when I'm "working from home" too

nikfubar · Post by **nikfubar** » Wed Jan 23, 2013 12:32 am

It's an M16 X 1.5mm

headcoats · Post by **headcoats** » Wed Jan 23, 2013 12:54 am

Cheers Furby

I must have a different thread on my new longer one i had made for the hybrid

Tried a castle nut which i had off fleabay which the seller said 1.5 pitch but it won't fit

Goes on about 2 threads then no more

nikfubar · Post by **nikfubar** » Wed Jan 23, 2013 8:17 am

1.5mm is quite a fine pitch far an M16, if you had one made they proberbly used a 1.75 or 2.0mm pitch die

headcoats · Post by **headcoats** » Thu Jan 24, 2013 11:34 pm

Furby is there a 1.25 pitch for an M16 ?

nikfubar · Post by **nikfubar** » Fri Jan 25, 2013 7:49 am

Well they make a 1.25 x 16 die
http://www.ebay.co.uk/itm/Metric-Die-Nu ... 2569a38196