Pistons

The place to talk about your Tandem!
Post Reply
dougindoors
Heavy Smoker
Posts: 361
Joined: Wed Jun 03, 2009 9:12 pm
Location: rochester kent

Pistons

Post by dougindoors » Mon Aug 22, 2016 9:52 pm

Has any one looked at AR125 pistons, look very close to me.
1984 Kawasaki KR250A
no projects, OOPS!1987 Kawasaki AR125B4
Every 2 in 1 poeple are schizophrenic
If you can not fix it with a hammer it must be electrical
2 Smokey and they bandit

User avatar
Top-shaggy
Premix Junkie
Posts: 1950
Joined: Mon Oct 31, 2011 11:09 pm
Location: Derbyshire

Re: Pistons

Post by Top-shaggy » Wed Aug 24, 2016 12:53 am

Wouldn't that be good :)
If it takes more than 2strokes then your just playing at it..

dougindoors
Heavy Smoker
Posts: 361
Joined: Wed Jun 03, 2009 9:12 pm
Location: rochester kent

Re: Pistons

Post by dougindoors » Wed Aug 24, 2016 4:35 pm

a little bit heavier, but the measurement's from the gudgun pin top the ring gaps and crown look the same, I haven't measured it accurately yet, but it looks dammed close.
1984 Kawasaki KR250A
no projects, OOPS!1987 Kawasaki AR125B4
Every 2 in 1 poeple are schizophrenic
If you can not fix it with a hammer it must be electrical
2 Smokey and they bandit

dougindoors
Heavy Smoker
Posts: 361
Joined: Wed Jun 03, 2009 9:12 pm
Location: rochester kent

Re: Pistons

Post by dougindoors » Fri Aug 26, 2016 2:54 pm

ar125 std piston 55mm, kr250 56mm so 1.0 os on the ar should fit, I will endeavour to get a vernier on both pistons this weekend.
1984 Kawasaki KR250A
no projects, OOPS!1987 Kawasaki AR125B4
Every 2 in 1 poeple are schizophrenic
If you can not fix it with a hammer it must be electrical
2 Smokey and they bandit

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests