Well, I got some new burs for the dremel recently, so decided to grab a spare damaged barrell and have a bit of a play. If it comes up good, I may do another to match and have them re-plated.
I used a KR1S barrell for inspiration, and will try to copy the port map as well.
I'd already smoothed the side transfer entries and knife-edged the dividers previously. I've only attacked the side transfer (upper left of pic) and the rear transfer port so far.
The close-up gives a bit better idea of howmuch meat has been removed.
The rear transfer no longer has that massive step at the gasket face.
Doing the port timming is really tricky since I dont have a right angle drive, but is still do-able..... just.
Still a long way to go though.
Been playing with the Dremel
- ScottaKR
- Premix Junkie
- Posts: 1521
- Joined: Fri Aug 10, 2007 2:52 pm
- Location: Australia
Been playing with the Dremel
KR250 Tandem Twin (Naked)
KR1 Red/White
KR1S Track Bike (has been put on hold for now)
ZXR750 H1 (Winter project)
KR1 Red/White
KR1S Track Bike (has been put on hold for now)
ZXR750 H1 (Winter project)