Hi,
MY outer right KIPS valve is a little bit stiff in the way that 1/5 times I turn on the ignition the vslve motor does not manage the first move because. It moves if I just tip it with the finger.
I read that this can be due to a head tighened to hard or not eq.
Can this be the reason? Or what could be the reason?
Thanks
Mouser
Again stiff KIPS valve
-
- Heavy Smoker
- Posts: 118
- Joined: Tue Nov 05, 2013 9:57 pm
- Location: Luxemburg
-
- Premix Junkie
- Posts: 1328
- Joined: Fri Apr 18, 2008 8:25 am
- Location: Solihull
Re: Again stiff KIPS valve
Might be worth checking if the KIPS cables are correctly adjusted. Also when the linkages get worn they can jam up if they go "over center". And have a look to see if the cables are fraying and are nice and free.
All worth checking before you strip the head off.
Andrew
All worth checking before you strip the head off.
Andrew
GWB KR1s C2 - Now gone
GWB KR1 - YES IT'S DONE!
ZXR400L PROJECT
AND NO S****Y H****A'S
Usque Ad Mortem Bibendum
GWB KR1 - YES IT'S DONE!
ZXR400L PROJECT
AND NO S****Y H****A'S
Usque Ad Mortem Bibendum
-
- Avgas Sniffer
- Posts: 3926
- Joined: Fri Jun 18, 2010 11:29 am
- Location: Oxfordshire
Re: Again stiff KIPS valve
Have you rebuilt your top end lately?
-
- Oil Injector
- Posts: 706
- Joined: Sat Aug 08, 2009 9:29 pm
- Location: the netherlands
Re: Again stiff KIPS valve
if you have rebuild tor topend and put to much grease on the bottum of the valve it can get stuck because the grease wil push your valve upwards.
Kr1s C1 zeus blue
Kr1s c2 black green
ZXR400 SP
ZXR250A
Kr1s c2 black green
ZXR400 SP
ZXR250A
- JanBros
- Avgas Sniffer
- Posts: 3306
- Joined: Wed Jul 26, 2006 11:50 pm
- Location: the land of Francorchamps
Re: Again stiff KIPS valve
check if all the valves have minimum play (you should be able to move them up and down a bit.
those that can't, sand the rind on top of the valves down a bit, or if you have a lath, turn them down.
if your cylinders have been matched in height at one time, it might have been possible the valves where adjusted like I said. if you didn't know about this and swapped valves/used others, the problem re-appeared
those that can't, sand the rind on top of the valves down a bit, or if you have a lath, turn them down.
if your cylinders have been matched in height at one time, it might have been possible the valves where adjusted like I said. if you didn't know about this and swapped valves/used others, the problem re-appeared
My ultimate goal is to die young as late as possible !