Referring to Part No.92200-1035 (see crankshaft diagram in parts book):
This washer was never fitted to B models and seemingly first appeared on the C1 and D1. I thought it may be a worthwhile addition to my B models, but I haven't got any of these washers and they are NLA from Kawasaki.
I have a few washers in my collection of old fasteners which look like they would work, but I'd like to know the dimensions of the original for comparison. Has anyone got a genuine flywheel washer lying around from which dimensions could be taken?
ID, OD and thickness please .
Thanks in advance,
James
Washer for KR-1S flywheel rotor bolt...
- James P
- Oil Injector
- Posts: 582
- Joined: Mon Mar 11, 2013 10:47 am
- Location: Sydney, Australia
-
- Light Smoker
- Posts: 37
- Joined: Sun Jun 29, 2014 3:50 pm
Re: Washer for KR-1S flywheel rotor bolt...
hi,
I'm new to the forum but i can help you.
dimensions are:
internal diameter-10.35mm
overall diameter-23.35mm
thickness-3mm
the washer is countersunk on one side(which faces the head of the bolt)as the bolt has a slight taper were it meets the head of the bolt.
total width of countersunk are is 15mm.
hope that helps.
graham
I'm new to the forum but i can help you.
dimensions are:
internal diameter-10.35mm
overall diameter-23.35mm
thickness-3mm
the washer is countersunk on one side(which faces the head of the bolt)as the bolt has a slight taper were it meets the head of the bolt.
total width of countersunk are is 15mm.
hope that helps.
graham