a lot of you know me on here.
i have done work on members bikes. from a service / complete engine rebuild,
caliper rebuild/ and also complete bike restoration. [see 9005rpm,s road and track bike and kiwi,s bike in the projects section]. currently i am doing kopite30,s kr1 [there are detailed photo,s of the builds,so you can see the quality of each part that has been done]
whatever work you need done on a kr1s / kr1 . however small. from a service. to a complete restoration.
just message me and i can give you my number, we can have a chat and work out what you want done.
all at forum rates and not silly garage costs.
i have built up contacts with various companys over the last couple of years, from aqua blasters/anodisers/and platers.
and only use a few very good companys, so the finish on the job i do is only to the correct standard.
below are some members bikes i have built.
from my own kr1-b2 and two forum members bikes i have built [the race kr1s has near on 60bhp at the back wheel. would of been more if standard pipes were fitted,as Nikons loose a bit at top end]
The area for businesses wishing to peddle their wares
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests