KR-1S.co.uk Forum

put a post on the FB page but thought i would put this here as well for people who dont have FB.

looking at purchasing these
http://www.ebay.co.uk/itm/271758224394
would some one be able to measure or confirm if these will fit onto the KR1-S exhaust directly or if they require a mount to be made.
im not able to get at my bike for a bit as its in storage but looking to get a few bits for it.

thanks

Lee

Confirming measured 44pcd with dia27 hole on muffler
25mm spigot for oring on stinger
HOWEVER ON KR-1S the two of the holes are at top most
So the curved outlet needs to be unriveted and rotated?
Or drill new holes in the tailpipe/stinger flange/to suit the orientation of tyga

Other than tht probbly best quality for cheaoest price WHEN BOUGHT DIRECT AT $44each without shipping and tax

spoke to tyga and i would need the brackets, and weld them.
seen somewhere on here that TZ250 fit even tho they are 2 bolt attachment or RS250.
from the picture i thought the rear part of the silencer pictured is welded on

Ordered a set of these today


so looking forward to them appearing.


should be some progress over the next few months as now have my own garage, shame its taken soo long as the new tyres i put on 7 years ago are likely scrap now (they havent been outside lol)