I would like your opinion

nate · Post by **nate** » Mon Dec 10, 2007 10:01 pm

mmm it just looks like it isnt part of the bike... kinda like a bolted on afterthought? Does that make sense

Definately look better if it was integrated into the seat unit.. with a hole or something?

mgtkr1 · Post by **mgtkr1** » Mon Dec 10, 2007 10:56 pm

is that a race ''keyless'' filler on the tank? looking good, cant wait to see the finished article. were did the filler come from? i think the pipe would be better suited with a round/pointy rs125 h***a 05/06/07 type seat unit. even aprilia may work. it would be ok with the kr seat if it was mounted so it protudes rather than underneath due to the shape.

r1-daz · Post by **r1-daz** » Tue Dec 11, 2007 8:34 am

I made the filler cap,and the fork tops,exhaust can,rear sets(not fitted yet),clip ons,brake pistons,steering damper mount and clamp,fuel tank breather,wheel spindles and spacers.....the list goes on ! !

the kid · Post by **the kid** » Tue Dec 11, 2007 9:10 am

Mmm , a half round cut out of the tail , offset to the side with only a little bit of the can protruding and shorten the tail pipe by at least half its lenght , but remember thats looking from down under tho .