Putting in new seals on the rear brake caliper but can't suss out how the anti ratlle plate/shim fits
I looked at the manual on here but it doesn't make it any clearer
Has anyone any pics or advice
Anti rattle shim on rear brake position ????
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
Anti rattle shim on rear brake position ????
Can it yer old boiler
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
Had another look at my shim (slow rebuild check date of last message !!!)
and it doesn't look like this ,even though i had it from Cradley Kawasaki
Mine is a one piece item and has bent over ends
if anyone would be kind enough to put another photo up with the shim fitted and minus the pads,that would be great [-o<
and it doesn't look like this ,even though i had it from Cradley Kawasaki
Mine is a one piece item and has bent over ends
if anyone would be kind enough to put another photo up with the shim fitted and minus the pads,that would be great [-o<
Can it yer old boiler
-
- Newbie
- Posts: 15
- Joined: Sun Sep 30, 2007 1:47 pm
- Location: North West
I think the one in the pic is one piece, just the angle of the photo.headcoats wrote:Had another look at my shim (slow rebuild check date of last message !!!)
and it doesn't look like this ,even though i had it from Cradley Kawasaki
Mine is a one piece item and has bent over ends
if anyone would be kind enough to put another photo up with the shim fitted and minus the pads,that would be great [-o<
The ones I have are the same as this .
Have you got a pic of the one you have?