Has anyone ever fitted an Aprilia RS250 rear wheel into a KR1S before? Iam after a suitable 17" back wheel to replace the 18"er which is in my hybrid at the moment.
I can not get a suitable tyre any more in the correct 140 profile as no one is making them any more......
All the best
Willie
Aprillia RS250 rear wheel
-
- Newbie
- Posts: 20
- Joined: Tue Aug 03, 2010 11:30 am
- Location: Bolton, Lancashire
Aprillia RS250 rear wheel
Never Stand in the middle of a Three Way Street
- the-elf
- Avgas Sniffer
- Posts: 2800
- Joined: Wed Jul 26, 2006 2:48 pm
- Location: Rockingham, Western Australia
The RGV 17" rear is a very easy fit and the drawings for the spacers are all ready on this site. the RGV takes a 150 rear or u can squeeze a 160 on it as its 4.5 " wide. Also don't forget to raise the ride height to compensate for the smaller tyre as well. That info is on here somewhere as well.
-- Lets go Racing
Sponsored by:
Paddockstand Ltd: Tyre and Bike spares http://www.paddockstand.co.uk
Sponsored by:
Paddockstand Ltd: Tyre and Bike spares http://www.paddockstand.co.uk
- scooble
- Premix Junkie
- Posts: 1549
- Joined: Thu Jul 27, 2006 12:47 pm
- Location: West Sussex
- Contact:
-
- Newbie
- Posts: 20
- Joined: Tue Aug 03, 2010 11:30 am
- Location: Bolton, Lancashire
-
- Oil Injector
- Posts: 872
- Joined: Mon Sep 07, 2009 8:33 pm
- Location: east yorkshire
-
- Newbie
- Posts: 20
- Joined: Tue Aug 03, 2010 11:30 am
- Location: Bolton, Lancashire
Yup, Martin is a mate of mine and has built an virtually identical engine to the one that is in his NSRD and also made a set of pipes to suit the tune.
Its running TDR250 reed cage, 6mm reed spacers, PWK28's with a full engine rebuild (new internals, crank, powervalves etc
Hoping for about 65BHP at the back wheel when it is finished.
Its currently with KAIS who are revalving the forks and shock and then need to get the jetting sorted for SATT on the first of July.
Willie
Its running TDR250 reed cage, 6mm reed spacers, PWK28's with a full engine rebuild (new internals, crank, powervalves etc
Hoping for about 65BHP at the back wheel when it is finished.
Its currently with KAIS who are revalving the forks and shock and then need to get the jetting sorted for SATT on the first of July.
Willie
Never Stand in the middle of a Three Way Street
-
- Oil Injector
- Posts: 872
- Joined: Mon Sep 07, 2009 8:33 pm
- Location: east yorkshire
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country