just stripped down the engine this morning and found a big end failure on the right hand cylinder.
As it was the road engine (spare) which had done about 24k, I'm not really suprised it let go.
The R/H piston is lunched, but at least the bores look Ok to use again.
As far as the other (40hp) engine is concerned, BDK said that they would 'look at it' and decide from there.
Think I might drive up to Norwich next weekend with the 40hp engine and the crank that just failed.
Here's the damage;
R/H Big end;
R/H Piston;
R/H Cyl
L/H Piston;
L/H Cyl;
.....how did that one get in there
sky ground sky ground, shiny plastic and molten metal
- scooble
- Premix Junkie
- Posts: 1549
- Joined: Thu Jul 27, 2006 12:47 pm
- Location: West Sussex
- Contact:
-
- Heavy Smoker
- Posts: 144
- Joined: Sun Dec 09, 2007 6:42 pm
- Location: Next to RAF Henlow
- Contact:
- scooble
- Premix Junkie
- Posts: 1549
- Joined: Thu Jul 27, 2006 12:47 pm
- Location: West Sussex
- Contact:
ports look good. Also have a standard set of KR1 cylinders (and head), and standard set of KR1S cylinders (one needs welding/plating) and head (needs work). One crank with leaking (inner) seals and another good for spares and two sets of cases - so in theory, I should be able to make at least one good engine out of that lot!
- kwackman12
- Oil Injector
- Posts: 924
- Joined: Wed Jul 04, 2007 10:06 pm
- Location: Reading
1hour 15min's old engine out new engine in & runningJanBros wrote:which can't be done in 1 hour375 wrote:Gary had to swap engines, bloody 4 strokes
Had a bit of practise this year! but to be honest iv'e neve had a fully refreshed engine in two years of racing & it does rev to 15500.
Trish rode well the weekend, don't think I could get a kr to go that fast around brands, but next year who knows I might be able to see if I can if it all goes to plan.
Here's a clip of the start where it all went wrong I clipped the guy & span him around then another plowed into him, don't mind posting this as everybody concerned walked away! https://www.dropbox.com/s/j8l8uzw7z3psw ... 5%2054.mov
As you can see we normaly have massive grids in the Bemsee 400 hopefully we will see a few more of you out there next year?
KR1 race bike
ZXR 400 Race Bike
Aprilia RS250
ZXR 400 Race Bike
Aprilia RS250
-
- Premix Junkie
- Posts: 1587
- Joined: Wed May 16, 2007 2:24 am
...that was nasty, and when the last of the grid is like 75m behind they are going real fast by the time they reach the front and acknowledge a problemkwackman12 wrote:JanBros wrote:Here's a clip of the start where it all went wrong I clipped the guy & span him around then another plowed into him, don't mind posting this as everybody concerned walked away! https://www.dropbox.com/s/j8l8uzw7z3psw ... 5%2054.mov375 wrote:Gary had to swap engines, bloody 4 strokes
As you can see we normaly have massive grids in the Bemsee 400 hopefully we will see a few more of you out there next year?
if the rider (on track left) hadnt recovered his wheelstand launch I would say another 5 riders would have come down as a group
.
.