While assembling the engine, kept having doubts about the fitment of the balance shaft cover, I'd managed to move the bearing so the pin wasn't sitting in its groove. Looking at the Stan Stevens pages now noticed I don't have the oil feed 'thing' fitted. Looking at some rebuilds, neither do a lot of other people
So... is it vital, or can I carry on without it??? I found a lot of debris inside the balance shaft that I cleaned out so this should help oil flow/travel to the other bearing.
Any one have a spare they wish to sell?
balance shaft
-
- Oil Injector
- Posts: 706
- Joined: Sat Aug 08, 2009 9:29 pm
- Location: the netherlands
Re: balance shaft
Do you mean the black plastic thingy.
Kr1s C1 zeus blue
Kr1s c2 black green
ZXR400 SP
ZXR250A
Kr1s c2 black green
ZXR400 SP
ZXR250A
-
- Oil Injector
- Posts: 706
- Joined: Sun Sep 30, 2007 5:59 pm
Re: balance shaft
Yes thats the part, wasn't sure what it was made of, is it important?
It looks like it feeds the bearing through the balance shaft, but doesn't the whole shaft, sit in a pool of oil anyway?
It looks like it feeds the bearing through the balance shaft, but doesn't the whole shaft, sit in a pool of oil anyway?
-
- Oil Injector
- Posts: 706
- Joined: Sat Aug 08, 2009 9:29 pm
- Location: the netherlands
Re: balance shaft
It is feeding the oil into the shaft but if you are rebuilding it i would buy it (still available by kwak) and put it in as it wil cost no more than a few quid.
Kr1s C1 zeus blue
Kr1s c2 black green
ZXR400 SP
ZXR250A
Kr1s c2 black green
ZXR400 SP
ZXR250A
-
- Oil Injector
- Posts: 706
- Joined: Sun Sep 30, 2007 5:59 pm
Re: balance shaft
Looks like it's another NLA part, all the UK sites have none available, anyone got a close up pic, not sure if it sits inside the balance shaft, or just takes oil into the chamber.
Does it spin with the shaft? or just sit there like a funnel. (my guess)
Does it spin with the shaft? or just sit there like a funnel. (my guess)