KR-1S.co.uk Forum

Uploaded with ImageShack.us

Not sure about Creme/Black paint jobbie now
But if it attracts the ladies then i may change me mind

now she looks like a real heartbreaker.........

Thats all well & good but where is her sense of health & safety?

I mean, how many of us could even walk in those motorcycle boots, let alone ride?

And where is the safety padding on that suit?

I wouldn't be suprised if she is stopped by the cops everywhere she goes.

Its an outrage I tell you. Little wonder motorcyclists are singled out for undue attention!

Nice arse though

f*&k h&s m8y with a bod like that..........pmsl.....

She looks good from that angle i will add, but never been a fan of keira knightly.
Should go back to playing with captain Pugwash.

all looks pretty cool, until you see this;


...oh dear

Well thanks a bunch Scooble, that's just ruined all my naughty daydreams for the next month

Is that really Keira Knightly?

Bugger, I was thinking there was a red head under that lid Must be the helmet lining that swung me that way?

I do like redheads (female variety that is)

Mind you saying that, if Keira Knightly was trying to thumb a lift down the m62 (it might happen [-o< ) I would 'carefully manoeuvre' over to the hard shoulder & offer her a lift, for free.

Such is the gentleman I am

Personally Howie i would give her the cold shoulder not hard shoulder

Got this pic yesterday , i popped round to see Ian Booms famous hybrid.
This is an early style NK Racing mod but he no longer does it like this with the ride height bolt.
I prefer this and this is what i want for my RGV swinger

http://www.youtube.com/watch?v=SbHY8yAW ... re=related

http://www.youtube.com/watch?v=rTeXaF4A ... re=related

http://www.youtube.com/watch?v=0yvFWhV9 ... re=related

Better pic of this paint job

Uploaded with ImageShack.us

Needle bearing in the swingarm proved a little difficult to remove,so had to get this done

Uploaded with ImageShack.us

NK billet ride height adjuster
I want to get this anodised black


Uploaded with ImageShack.us

Aprilia Rs 250 rear caliper

I want the anodised finish removed off the outside faces to leave a natural alloy finish but would like to keep the anodising on the inside to protect the seal area
Any ideas ?

nylon brushes on a drilling machine should do the trick

Tried the one RGV fork bottom on the KR1S wheel to see where about the disc is etc and it looks like it will fit albeit with spacers.
i forgot the camera

them vids make me want another 'valve'..........