Page 3 of 15
Posted: Sat Apr 27, 2013 12:25 am
by garye345
No,chain guard is only an adviceory not a fail.
Re: Project KR1SS - So far
Posted: Fri May 24, 2013 11:41 am
by Kneewall49
Gary,
Did you have that engine vapor blasted while assembled?
Re: Project KR1SS - So far
Posted: Fri May 24, 2013 11:42 am
by martin
the engine was fully stripped , then aqua blasted. you cant aqua blast a complete engine,
Re: Project KR1SS - So far
Posted: Sun May 26, 2013 9:12 pm
by gary
Re: Project KR1SS - So far
Posted: Mon May 27, 2013 11:50 am
by James P
gary wrote:...set the speedo back to zero...
Dare I ask how you did this without damaging the bezel or casing?? Did you open it up, or simply run it in reverse??
I want to open up one of my speedos to repair a dodgy number dial.
Lovely bike by the way!
Thanks & regards,
James
Re: Project KR1SS - So far
Posted: Mon May 27, 2013 11:57 am
by martin
I know someone that does speedo repairs, and various other stuff.
got garys done for him
Re: Project KR1SS - So far
Posted: Mon May 27, 2013 8:26 pm
by 375
James P wrote:gary wrote:...set the speedo back to zero...
Dare I ask how you did this without damaging the bezel or casing?? Did you open it up, or simply run it in reverse??
I want to open up one of my speedos to repair a dodgy number dial.
Lovely bike by the way!
Thanks & regards,
James
viewtopic.php?f=8&t=7450
First page.
Re: Project KR1SS - So far
Posted: Wed May 29, 2013 8:02 am
by James P
375 wrote:Got the rim of very easy a screw driver under the rim lip and twist the edge up all the way round.
Ah, yes! I'm sure I'd already seen the topic you referred to - I must have skimmed over that part!
Thanks & regards,
James
Re: Project KR1SS - So far
Posted: Fri Jun 14, 2013 2:47 pm
by RalfK
Re: Project KR1SS - So far
Posted: Sat Jul 13, 2013 2:50 pm
by gary
Please see video below of the project so far... (double click on pic

)

Re: Project KR1SS - So far
Posted: Sat Jul 13, 2013 2:57 pm
by martin
sounds good gary,
once you have done a few miles on it, we will have to book it on the dyno,
I know I spent some time flowing the cases, and matching the barrels, so would be nice to know
what the bhp at the back wheel would be,
I will come to the dyno with you and bring some tools and diff size jets

Re: Project KR1SS - So far
Posted: Sat Jul 13, 2013 4:25 pm
by 500bernie
Looking really nice Gary

Re: Project KR1SS - So far
Posted: Sun Sep 08, 2013 11:37 am
by martin
I have finished flowing your crankcases gary. so should have a few more bhp. esp with the v force reeds/and other mods.

Re: Project KR1SS - So far
Posted: Sun Sep 08, 2013 2:24 pm
by 500bernie
Nice job Martin =D>
Re: Project KR1SS - So far
Posted: Sun Sep 08, 2013 6:36 pm
by Top-shaggy
500bernie wrote:Nice job Martin =D>
X2 =D> =D> =D>