new paint picture added

[kghost]

Been out of town the last few weeks working.

Finally getting back on the project.

Doing a bit of Mock Up.......

[500bernie]

I like the look, especially the polishing on the frame.
Where are you mounting your ignition switch?
Cheers
Bernie

[kghost]

I like the look, especially the polishing on the frame.
Where are you mounting your ignition switch?
Cheers
Bernie

Haven't picked a firm location yet. Still building mounts.

Will have a better idea when I get into running the wiring for the Acewell......

Probably through the right side cover. The same position as the petcock but on the opposite side.

[500bernie]

How about on the tail unit using the existing hole for the seat release?
I think your motor should get the same attention that your frame got.




Cheers
Bernie

[kghost]

I wish my engine were that shiny.

Had to draw the line somewhere or I'd never get to ride it.

Got my Acewell wired in to the stock loom. Key relocated etc.

Pic's to follow.

[kghost]

http://www.youtube.com/watch?v=hBI6B97WkD0

[375]

As soon as i saw it was sunny i knew it wasn't the UK, looks fun

[kghost]

My project is at the paint shop..........

[kghost]

Well....just trying to be part of the community lol

[500bernie]

Nice job
How did you get it past its road worthy test with a rear seat but no footpegs?

[kghost]

Nice job
How did you get it past its road worthy test with a rear seat but no footpegs?

Its solo Seat compliance here in Oz. Cheaper rego.

Seat has to be 500mm or less. Its exactly 500 mm with both.

Plan to get rid of that rear seat down the line.

[500bernie]

Davey does a fantastic hard tail that just clips on in place of the rear seat

[philfingers]

interesting you have the seat release lock on the RHS of the bike

[500bernie]

Hi Phil,

The seat lock/unlock mechanism is much lower than that........It looks like an ignition switch

[kghost]

The seat release hole was plastic welded over.

That is on fact the ignition. Good eye Bernie