KR-1S.co.uk Forum

mk2 front end is on
engine is sort of back in


ally shiney ally mk2 rear subframe

Awesome, overtime required with the Solvol to bring that up to mirror finish :
It's probably the angle you have took the photos from, but what is the ground clearance at the lowest point on that bottom pot?
Cheers
Bernie

500bernie wrote: It's probably the angle you have took the photos from, but what is the ground clearance at the lowest point on that bottom pot?
Cheers
Bernie

a better picture on page 5 shows there is plenty

Cheers Jan

Gary when I am next passing do you want me to pop in with my Solvol, I am running out of things to polish (I only have my spare calipers to finish)
After that I am going to have to get myself a new project

Cheers
Bernie

Solvol rehab for you again, Bernie

Enjoying following your build, looks brilliant, can't wait to see more of it coming together..

lovely project. =D>

here someone is making a similar project:
http://www.2t-special.it/forum/viewtopi ... 4&start=60

Cheers
Dirk

thats a bike alex in italy is building for a customer
he did what he was paid to do then handed it back to he owner he had to fit he engine and make some exhausts and fit a wider rear wheel ,thats why it stopped months ago ,the owner doesnt want to posta about it
ive been in contact with him for nearly a year
another was built as a race bike in 2006 i think by someone else
and ive been in contact with a lad who did a lot of work on that one ,it has jolly moto pipes on that one

did a bit more
tank and seat were just to get an idea of how it will look

I am afraid that you have on the right side too little cornering clearance ...

dirk wrote:I am afraid that you have on the right side too little cornering clearance ...

Are you calling Gary fat?

dirk wrote:I am afraid that you have on the right side too little cornering clearance ...

viewtopic.php?f=8&t=12100&start=60

the pipe will not touch the floor
it is going to be another 2 inch higher at the front and 30mm at the back
once its sorted , tyre on the front is just to stop rinm scratching its not blown up or wide enough
so once its coated and it gets a new tyre it will be a good bit higher ,and rear is getting 30mm jackup
ive lent bike well over and its almost got bar on the floor before pipe is ,
camera must be making it look worse than it is

It doesn't look that bad to me from the photos Gary

Luders wrote:It doesn't look that bad to me from the photos Gary

its not bad at all , no way will it touch