Page 1 of 1
Made this for the KR, What have you made?
Posted: Sat May 30, 2015 9:05 am
by TurboStew
Hi all, when I got my KR the Fairing cover was lost that covers the hole to inspect the cooling system. I used a laser cutter to make a new cover out of acrylic. came up pretty good I think.
Cheers Stew
Re: Made this for the KR, What have you made?
Posted: Mon Jun 01, 2015 3:58 am
by fuad
=D> =D> =D> =D>
Re: Made this for the KR, What have you made?
Posted: Thu Jun 18, 2015 2:02 pm
by TurboStew
I put up this post hoping to inspire others to share their talent for innovation of repair. Come on guys surly you have some talent to enlighten us all with and some fantastic
on how to bring back the life in the old KR.
Re: Made this for the KR, What have you made?
Posted: Thu Jun 18, 2015 4:06 pm
by StrokerBoy
Go on then, since you asked nicely.
Here's the hand-made wooden bottom-yoke bearing on my KR250 special...
Don't worry, it's not staying like that - it's so I can push it around the garage in one piece.
Re: Made this for the KR, What have you made?
Posted: Fri Jun 19, 2015 8:20 am
by Top-shaggy
=D> =D> =D>
Re: Made this for the KR, What have you made?
Posted: Fri Jun 19, 2015 11:13 am
by TurboStew
That's it, that will do for what you intend to use it for StrokerBoy. Nice lathe work.
keep them coming Guys. It could get very interesting.