KR-1S.co.uk Forum

My engine hasn't turned for at least 2 1/2 years, so as well as the missing / damaged stuff I'm going to replace all oil seals, water pump seal etc.

I'm looking at all seals, piston rings, small ends, piston circlips, some locating dowels, kipps links, carb rubbers.

It's become quite a long list of fiddly bits and pieces - who would you use ?

On the carb rubber front - they look perished on the outside, but can't see any damage internally - am I being too cautious ?

Also, where can I get a flywheel puller ?

Thanks

Tambo

Flywheel pullers are quite cheap to buy can't remember here you get them from ATM. I jyust made my own just remeber its a Left handed thread or you'll end up making two of them

You could Try Z power for parts

Tambo wrote:On the carb rubber front - they look perished on the outside, but can't see any damage internally - am I being too cautious ?

Someone on the old forum mentioned covering them in some kind of silicone, or liquid rubber, I am sure someone knows how to do this
Cheers
AL

cradley heath well recommended