KR-1S.co.uk Forum

Putting in new seals on the rear brake caliper but can't suss out how the anti ratlle plate/shim fits
I looked at the manual on here but it doesn't make it any clearer
Has anyone any pics or advice

Hi, This is the only picture i've got hope it can help. Regards Mark

Cheers mate i can sort it out from that

Had another look at my shim (slow rebuild check date of last message !!!)
and it doesn't look like this ,even though i had it from Cradley Kawasaki
Mine is a one piece item and has bent over ends

if anyone would be kind enough to put another photo up with the shim fitted and minus the pads,that would be great [-o<

headcoats wrote:Had another look at my shim (slow rebuild check date of last message !!!)
and it doesn't look like this ,even though i had it from Cradley Kawasaki
Mine is a one piece item and has bent over ends

if anyone would be kind enough to put another photo up with the shim fitted and minus the pads,that would be great [-o<

I think the one in the pic is one piece, just the angle of the photo.
The ones I have are the same as this .

Have you got a pic of the one you have?

Hello Howard

It's sorted now
I went down Quasimodos to see his