KR-1S.co.uk Forum

I have only seen the wheel in bits and the question is can you get the
2 wheel spacers mixed up
Could someone maybe post a pic of the spacers to show correct installation
As i have it in the swinger at the moment the top hat bit sticks out a few mm on the sprocket side from the seal.
Is this correct

Yes, it is very easy to get them mixed up, did it last week
Couldn't work out why the caliper wouldn't fit
The pictures in the manual do not make it clear.
The top hat with the thicker flange goes on the sprocket side.
Hope this helps,
Mike.