Piston sizes

Twangled your powervalve grommit in your woodruff key? ask someone how to fix it here
Post Reply
Skinnybob46
lurker
Posts: 3
Joined: Sat Aug 19, 2017 6:37 pm

Piston sizes

Post by Skinnybob46 » Sun May 19, 2019 8:01 pm

Hello, looking on Wemoto.com for replacement pistons, there's A,B,C and D of slightly different sizes can anyone advise. The barrels haven't been messed with. Thanks

User avatar
500bernie
Avgas Sniffer
Posts: 3256
Joined: Mon Aug 02, 2010 10:22 am
Location: Teesside

Re: Piston sizes

Post by 500bernie » Sun May 19, 2019 9:08 pm

Your barrels will have their size letter stamped on the top of the exhaust manifold.
Firecracker Red and Grey C3 300
Image

User avatar
JanBros
Avgas Sniffer
Posts: 3076
Joined: Wed Jul 26, 2006 11:50 pm
Location: the land of Francorchamps
Contact:

Re: Piston sizes

Post by JanBros » Mon May 20, 2019 12:00 am

500bernie wrote:
Sun May 19, 2019 9:08 pm
Your barrels will have their size letter stamped on the top of the exhaust manifold.

but you never know if they have already had new nicasil, because if they have the code is wothless
You know it's cold outside when you trip over dog shit instead of standing in it.

Gerrit
Heavy Smoker
Posts: 356
Joined: Fri Jun 26, 2009 12:09 am
Location: Kingdom of the Netherlands

Re: Piston sizes

Post by Gerrit » Mon May 20, 2019 8:46 am

Best measure the bores first, then use the measurements to choose the piston size.
"Mine is a long and sad tale", said the mouse.
"Indeed it is", said Alice, looking at the mouse's tail.

User avatar
KR-1R
Premix Junkie
Posts: 1450
Joined: Wed May 16, 2007 2:24 am

Re: Piston sizes

Post by KR-1R » Wed Jun 19, 2019 2:53 am

.
.
Cylinder Bore -minus running Clearance = Piston size
for Wiseco, Wossner and VHM where the pistons are forged, 0.07-0.08 mm is specified
for OEM or cast piston the material expands slightly less so are set tighter at 0.04-0.05 mm clearance

so if you cylinder is marked B and new, you need B size pistons
if your cylinder is stamped B and has many hours or rebuilds (worn) on it you will need a C or D size piston

"When a modern forged piston with more initial cold clearance reaches operating temperature, the difference in running clearance is less than might be surmised. For example, Wiseco uses 2618 and 4032 alloys for all its forgings. While the expansion rates are different for each alloy, Wiseco has made pistons from each alloy for the same engine operate successfully at nearly the same running clearance. The higher-expanding 2618 piston may have a larger initial clearance than a 4032 piston, but once the engine reaches operating temperature, both pistons will have similar running clearances."
to copy one thing is plagiarism - to copy two things is called research

Post Reply