Page 1 of 1
sprocket carrier studs
Posted: Mon May 18, 2009 8:49 pm
by pablo
I'm strugling to find sprocket carrier studs for our KR1S any suggestions
paul
Posted: Wed Jun 10, 2009 11:52 am
by pablo
Come on
](./images/smilies/eusa_wall.gif "Brick wall")
somebody must've replaced the studs ours where absolutely shagged n all the sprocket carriers I've looked at hav'nt been much better.Found these but look at the price.
http://www.gpzzone.co.uk/acatalog/Chain ... ckets.html
Help please [-o<
Posted: Wed Jun 10, 2009 12:05 pm
by kwackman12
Try your nearest exhaust centre, they should stock studs, as they use them in manifolds etc
Posted: Sat Jun 13, 2009 7:16 pm
by pablo
Tried that mate,not quite right tho.I've found a nice zxr750 carrier thats got nice clean studs in it.
How can I get then out without damaging the studs or the carrier
Tried locking two nuts together without joy.
Posted: Tue Jun 16, 2009 9:11 am
by headcoats
I would just buy the studs from that link you put up
That's cheap compared to most bike parts
Posted: Tue Jun 16, 2009 9:29 am
by the-elf
Can't you just get some bar stock and make some or get someone you know to do it for you? Should only take 5 mins to do.
Posted: Tue Jun 16, 2009 12:39 pm
by tornado
you can stainless steel studs from WDS
http://www.wdsltd.co.uk/Fixings,%20Torq ... 801%20Stud
these will be normal pitch threads and not the fine pitch the the japanese tend to use - BUT I'm sure the sprocket studs are M8x1.25 - not 100% sure though!
Paul