KR-1S.co.uk Forum

Posted: **Sat May 23, 2009 7:45 pm**

One of the front KR1S calipers on my Hybrid is weeping throught the threads

Is there anything i can do about this ?

Posted: **Sat May 23, 2009 11:22 pm**

Check to see if the caliper has a hairline crack in it first, if it all seems ok you could use PTFE tape on the nipple (the white tape plumbers use)

Posted: **Sun May 24, 2009 8:23 am**

been searching the archive on the RD site about this and as i'm using S/S bleed nipples i had from Hel brakes this may be a problem

The angle on the taper is not quite the right ??????

Should i get some Kawa genuine bleed nipples to try ?

Then saw some of thes speed bleeders type and they have a coating on the threads

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0049787355

http://www.mandp.co.uk/productinfo/5160 ... es/Russell

Plus these look like they have a rubber type sleeve on the threads
http://www.demon-tweeks.co.uk/products/ ... GDRBN704SB

Posted: **Mon May 25, 2009 1:58 am**

The speedbleeders come with a coating on the thread to help them seal. They are very good, I run them in my bikes, the make bleeding the brakes a very simple task. The only thing I have heard bad about them is that they can break if you overtighten them.

In the past I have used PTFE/plumbers tape to make the seal. Done it on road and race bikes.

KR-1S.co.uk Forum

Weeping Nipple !!!!!

Weeping Nipple !!!!!