RGV rear wheel spacers.
Posted: Thu May 11, 2023 2:44 pm
Hi guys.
A question regarding RGV spacing in an S swingarm.
I have a top hat spacer on left, spacer within the sprocket carrier and a plain spacer between bearing and caliper mount (as per this thread viewtopic.php?p=9193#p9193).
The wheel (with new 40X17 bearings) spins freely but is not centred within the arm. It seems to be sat too far to the right.
I’ve measured from centre of swingarm pivot to centre of rear axle and the wheel is straight.
Have I done something wrong or do I have incorrectly machined spacers?
Thank you.
Mark.
A question regarding RGV spacing in an S swingarm.
I have a top hat spacer on left, spacer within the sprocket carrier and a plain spacer between bearing and caliper mount (as per this thread viewtopic.php?p=9193#p9193).
The wheel (with new 40X17 bearings) spins freely but is not centred within the arm. It seems to be sat too far to the right.
I’ve measured from centre of swingarm pivot to centre of rear axle and the wheel is straight.
Have I done something wrong or do I have incorrectly machined spacers?
Thank you.
Mark.