Page 1 of 1
Posted: Wed Jul 15, 2009 7:36 am
by buzinc
I believe its the same as the crank and needs to be pressed off/on then balanced. Not a home jobby.
Speak to somebody like;
http://www.bdkraceeng.co.uk/
Buz
Posted: Fri Jul 17, 2009 10:37 am
by buzinc
Hummm i'me guessing there is no part available. Looking at;
http://www.cmsnl.com/kawasaki-1990-c2-k ... E1320.html
It seems balancer comes as a unit from big K, just like the crank. I think you have two options. If you are sure your seal is gone, find another balancer shaft from one of the guys on this forum - not sure bout shipping cost to Australia.
Or have your existing unit taken apart, measure and post pics of the seal on forum, and see if anybody can match an alternative kawasaki part.
Unless somebody else has had this prob, any comments?
Buz