Page 1 of 1
mechanical seal water pump
Posted: Wed Sep 30, 2009 4:31 pm
by Charles
Hi,
this seal failed on my KR1S.
Now got hold of this new seal, it looks different from the one that was fitted:
It consists of two parts:
Is it the correct seal to use? I suppose the rubbery seal points to the impeller?
Thanks,
Charles
Posted: Wed Sep 30, 2009 4:52 pm
by JanBros
never seen this one. you got this from a Kawa dealer ?
Posted: Wed Sep 30, 2009 4:56 pm
by Charles
JanBros wrote:never seen this one. you got this from a Kawa dealer ?
no off ebay, but it was in an originally sealed kwak bag with part no. 49063-1055......
Charles
Posted: Sun Nov 22, 2009 12:37 pm
by Charles
JanBros wrote:never seen this one.
you're sure, Jan?
Dismantled another waterpump today, found the above seal (or whatever it is) in the back of the impeller:
Can any confirm this? Perhaps Howie, he posted a pic of his impeller lately IIRC.
thanks,
Charles
Posted: Sun Nov 22, 2009 1:17 pm
by martin
that is the correct seal charles, rubber side facing out to the impeller just rebuilding my engine[total strip down done on my bike] wait until you all see it, how it was before is nothing to how it will be when finished]
Posted: Sun Nov 22, 2009 1:24 pm
by Charles
thanks Martin! Good to see you back here, already thought you had vanished
looking forward to seeing your bike
Charles
Posted: Sun Nov 22, 2009 1:29 pm
by martin
no problem charles. just had a few health and work problems, but i will sort it
Posted: Sun Nov 22, 2009 9:01 pm
by Bikemike
Welcome back Martin, there has been a lack of shinyness* on the forum while you have been gone.
Mike
*made up word!
Posted: Sun Nov 22, 2009 10:14 pm
by kwackman12
martin wrote:no problem charles. just had a few health and work problems, but i will sort it
Think there's been a few people with problems lately
Welcome back Martin hope you have them all sorted