Page 1 of 1
S fairing stay & fairing brackets
Posted: Wed Nov 04, 2009 1:44 am
by rgvlee
Hey all, hoping a few of you can shed some light on the upper fairing stay for me. I am about to start repairing a few bits of fairing and want to make sure everything is straight - bracket wise - before I begin.
Is the lower mount point meant to be on an angle compared to the upper mount point? Was kawasakis quality control a bit dubious on these? The photo makes it look a lot worse than it actually is.
Posted: Thu Nov 05, 2009 9:17 am
by Ian_B
Here's a fairing stay to compare yours with.
[/img]
Posted: Mon Nov 09, 2009 12:49 pm
by rgvlee
thanks mate
any more guys?
the fairing stay that I posted is meant to be new old stock
I have a damaged fairing stay that is similar with the angled lower mount. looking at the bracket, it's a pretty solid point, and it would be really obvious if it had been repaired.
Posted: Wed Jun 16, 2010 9:45 am
by rgvlee
Bumping this one again
Any more input? I need to know if I have to repair the fairing mount before painting. It's even more critical for me as I have had to have the top headstock mount repaired due to previous damage so I have no idea how far off I am.
Posted: Wed Jun 16, 2010 10:17 am
by Charles
Hi Lee,
rgvlee wrote:
Any more input?
I'll have a look later today when I'm home again.
Charles
Posted: Thu Jun 24, 2010 4:30 am
by rgvlee
I have 2 of these, both lower headstock mount is not square
NOS one:
Old one, which has been damaged from a previous drop
I can understand the old one being bent, but the NOS one?
Posted: Wed Jun 30, 2010 8:23 am
by Charles
Sorry Lee, forgot all about you
Mine are both straight.
Charles