KR-1S.co.uk Forum

I bought this bike with a view to restore it, unfortunately there are too many parts that are missing or damaged to make this viable. I will be dismantling the bike to sell off as spares, please let me know what you need and what you feel is a fair price. My email address is rowlandsons@optusnet.com.au. The main problem with selling bits is the extortionate cost of postage, I recently bought a plastic side cover for a h***a, the US vendor wanted $49 as his standard flat rate overseas parcel cost. I will charge postage at cost for all parcels.

pm'd

What parts are missing?

Lots of missing bits-- ignition switch innards, key for fuel cap, plastic side covers( both sides, all air intake parts( carbies are there but nothing else)mirrors, indicators, coil on RH side,plug leads.
The bike has slid down the road at some time, RH clip on is bent,rear cylinder has had a ring breakup at some stage, previous owner fitted a new piston but kept gouged barrel, looking at the piston the engine has not run much in this state.Water pump and pipework show signs of long term storage but will clean up OK,oil pump is good carbies good but one has the plastic choke cable retainer broken.

Apart from the piston and barrel damage all that seems like the usual stuff that would be missing off a project bike you get for $260. Not sure what you were expecting for that money . Why dont you give it a go there is a bloke in Sydney with a good few bits.