Page 1 of 1
RGV Forks with KR1S wheel How ??
Posted: Tue Aug 10, 2010 9:49 am
by headcoats
Has anyone fitted RGV 250 forks and then refitted the KR1S wheel ?
Can it be done and what discs,calipers spacers etc do you use
Can the speedo drive be fitted o.k. too ?
Any Piccies
Posted: Sun Sep 26, 2010 6:12 pm
by headcoats
Anyone done it then
Posted: Sun Oct 03, 2010 7:26 pm
by headcoats
Right i have bit the bullet and now this is the mod i will be wanting to do so if anyone has any info please.
Is there any reason it wouldn't fit ? what problems might i come up with ?
Posted: Sun Oct 03, 2010 10:18 pm
by Bikemike
headcoats wrote:Anyone done it then
Not as far as I know.
I've been lurking on this, and other, forums for too many years and I haven't come across it done. It may have been done in the 90's but I've never seen anything in print about it.
Good Luck!
Mike
Posted: Mon Oct 04, 2010 9:12 am
by headcoats
Just emailed the Guru of LC builds Nigel at NK Racing and he don't know either
Posted: Fri Oct 08, 2010 8:51 pm
by andy b
why not do the rgv rear wheel conversion and fit the rgv front end, this will allow you to get good quality 17" tyres
Posted: Sat Oct 09, 2010 9:17 am
by headcoats
I have an Aprilia RS 250 wheel for the back
and needed a similar 5 spoke front wheel but with a speedo drive because i'm keeping the standard LC clocks .
Posted: Mon Oct 18, 2010 5:37 pm
by headcoats
Saw a KR1S with RGV forks and a KR1S front wheel at the Stafford show but had no camera
But it looked like it used the KR discs and even the KR calipers
Note to self take the feckin camera next time