KR-1S.co.uk Forum

Hi, does anyone know if the torque arm joints are still available, and how much please, got one thats quite rusty, but seems to work ok after cleaning, movements nice and tight still.

They were available from Kawasaki when I was refurbing the torque arm but hellish expensive.IIRC

You can get identical rose joints from good bearing suppliers.

I got the boots from Zpower as ours were split.

Thanks, I did wonder if they were just a standard knuckle, 8mm hole 10mm thread, any idea what the little sticky out thing is, I assume its an oiling point. Boots are fine on both of mine too, just re-plated the zinc parts, and now need to paint the arm.

Just a quick update and for those that might be looking, I bought these from McGill motorsports, they are identical to the ones fitted as standard, even have the little brass pip on them, not bad at £10 for both.

http://cgi.ebay.co.uk/M10-Male-Rose-Joi ... 2c4c1d264c

[/quote]Just a quick update and for those that might be looking, I bought these from McGill motorsports, they are identical to the ones fitted as standard, even have the little brass pip on them, not bad at £10 for both.

http://cgi.ebay.co.uk/M10-Male-Rose-Joi ... 264c[quote]

How did these work out?

Tel[/quote]

I haven't fitted them yet (just got the frame back from the coaters a few days ago), but i couldn't tell the difference and would say they are identical? if they don't last long, not a big job to change them again.

Looks like i'll be the guinea pig with these then.

Just ordered some - mine are proper foooked like!!

Tel