KR-1S.co.uk Forum

Any advise on where to get end cans for my KR1. I have looked on E-bay and they range from £25 - £110 each. Not keen on the look of the cheap ones so they are out but the others dont look to bad. Need to be street legal. Will probably need to cut the cans off my std pipes. Would be a shame though as they are mint.

http://www.ebay.co.uk/itm/NSR-250-KR1S- ... 53dd4e1ccd


http://www.ebay.co.uk/itm/NSR250-KR1S-R ... 3ef8f95891
Davy

why do you want to replace your mint KR-1 pipes?

Was unsure about it and then I posted pictures on this site and lots of comments were about the pipes so was fairly convinced that its the thing to do.

I need to have a look now

let me know what you think

Right, I know what you mean now, but I have this to say.

Please don't cut up your B exhausts.

If you don't have a spare £800 quid for some Lomas', pick some second hand C spannies and stick some after market carbon end cans on them.

Luders wrote:Right, I know what you mean now, but I have this to say.

Please don't cut up your B exhausts.

If you don't have a spare £800 quid for some Lomas', pick some second hand C spannies and stick some after market carbon end cans on them.

Davy
I have to agree with Luders, I wouldn't cut up the KR1 pipes. Take them off and save them for your next project (or sell them to a forum member as they are rare in good condition)
Then use something else like the S pipes or Lomas / moto

Davy
I have MIG end cans on mine with standard 1s pipes, i will be selling the end cans if and when i can get a pair of very good original cans, i have put a few feelers out on the forum [-o<

I also would avoid cutting up a good pair of pipes,

PM sent.