Page 1 of 4
9005RPM,S TRACK BIKE
Posted: Tue Nov 13, 2012 1:48 pm
by martin
started 9005rpm,s track bike this week.first picture not much, just the swinger cleaned and re greased.
this is going to be a good bike, bill from bdk was not much short of £1000.
barrels all sorted and renicosiled. head skimmed and reprofiled to run
Yamaha tz 26j pistons and a fully rebuilt crank.
professor is rebuilding a tech 2000 rear shock.
Posted: Tue Nov 13, 2012 1:52 pm
by martin
shock was badly in need of a rebuild. should look and work a lot better when it comes back
these are the spannies that will be going on
standard head[left]skimmed and reprofiled for 26j pistons[right]
Posted: Tue Nov 13, 2012 2:22 pm
by martin
top end and crankshaft fully sorted
Posted: Tue Nov 13, 2012 7:09 pm
by 500bernie
Nice work Martin =D> =D> =D>
The start of another great thread (and rebuild)
I can find the details for the smaller of the two bearings we talked about: 601A6201 but I cannot find the details of the large bearing that holds the output shaft to the clutch.....help!
Cheers,
Bernie
Posted: Tue Nov 13, 2012 7:18 pm
by scooble
what spannies are they?
Posted: Tue Nov 13, 2012 7:44 pm
by martin
nikons tricia
swapped them for a nice set of standard exhausts with daz680
Posted: Tue Nov 13, 2012 9:52 pm
by scooble
ahh, they must be the early ones then
Posted: Fri Nov 16, 2012 5:28 pm
by martin
got the tech 2000 shock back from the professor today
Posted: Wed Nov 21, 2012 2:37 pm
by martin
getting there. engine nearly done.
fully sorted barrels/skimmed and reprofiled head [running single ring yam
tz 26j pistons] barrels all matched to cases. fully rebuilt [including new centre shaft] crankshaft. plus a few other bits matched up, new electrix world stator.
fasteners now back from the platers. just got to remember where everything goes.
Posted: Wed Nov 21, 2012 4:48 pm
by martin
wheels back from triple s/new avon am22/23 tyres/new bearings/
Posted: Wed Nov 21, 2012 5:56 pm
by headcoats
Just about to get my wheels done in gold
Posted: Wed Nov 21, 2012 6:34 pm
by maccas
Will it be running stock porting Martin? Looking good by the way!
Dan
Posted: Wed Nov 21, 2012 6:42 pm
by martin
the ports have been worked on previously, nothing major, but a nice
job. I spent a bit of time with the dremmel. matching everything up.
surprising how much out the head and barrels are when you hold base
and head gaskets up to them.
water holes now all match up and water pipe also opened up [have a look
down inside one and you can see the flow can be improved]
Posted: Thu Nov 22, 2012 6:25 am
by ScottaKR
martin wrote: just got to remember where everything goes.
C'mon martin, you should be able to bolt a KR back together in your sleep by now.
Posted: Thu Nov 22, 2012 5:13 pm
by martin
got a bit done today
engine and a few more bits now on
