KR-1S.co.uk Forum

Hi All
Its been a while since I last posted, life seems to have gotten in the way.
More like my young blokes riding motocross and speedway got in the way.

Anyhow I finally got around to rebuilding my KR1S motor after about a year of lost motivation, powder coated the frame and gave it a good tidy up while I was at it.
Today while I was checking to make sure I was getting the right amount of oil from the injectors I just had to give the banjo bolts on the pump one last tweak to make sure they were tight. SNAP !!

The damn pipe/fitting broke right where it leaves the round banjo that fixes to the pump. It has broken on the metal part of the banjo fitting

Are these pipes available ? I heard not
Has anyone made a way around this ?

I'm thinking if I can get a small enough hydraulic banjo fitting I can just run hose to the check valves on the inlet rubbers

I might have some you can have.

I'll have a hunt through the spares and see if I've got a pair for you Bert.

That's a better option if you have some Scott

Thanks guys
Of course I'll pay for them and postage

Thanks

Just had a look and found a suitable set. Will try and get them packaged up tomorrow (knackered from the heat and o/t at work atm). PM me your details so I can sort out postage Bert.