KXR-1SS

[JanBros]

she's alive

don't knwo what's wrong with the ignition, but she wouldn't start. thought it was me kicking her like a softy. couldn't get more then some flames out off the exhaust .... so started thinking the ignition timing is wrong. made a tool so I could spin the cranck with an electrical drill and with the stroboscope it was clear she fired too late (although set like in the manual). gave her a lot more advance and she fired up

http://www.youtube.com/watch?v=YogBS5Er3Lg

from 30sec's on, you can see a special anti-wheely-device apparently build into the engine , didn't know off that, first time I've seen it

as always : with good news comes bad news : water leaking in the gearbox, oil leaking on the kickstart seal, and oil leaking on the outpushaft but still feeling happy

[ScottaKR]

Looks like a result to me. =D> =D>
That's some pretty mad torque to pump the front forks down like that, but I doubt it'll stop you popping wheelies at a moments notice.
How long till we see a first ride on this animal.

[JanBros]

How long till we see a first ride on this animal.

when I buy a chain

[smithyrc30]

she's alive

from 30sec's on, you can see a special anti-wheely-device apparently build into the engine , didn't know off that, first time I've seen it

That anti-wheely-device is cool, where do you get them from?

[JanBros]

she's alive

from 30sec's on, you can see a special anti-wheely-device apparently build into the engine , didn't know off that, first time I've seen it

That anti-wheely-device is cool, where do you get them from?

I guess from the massive torgue a 500 single produces

[pablo]

I doubt it'll stop you popping wheelies at a moments notice.

Too right I reckon you will need to wear a gum shield,cos that front end will be coming up

Good work Jan =D>

[ScottaKR]

I doubt it'll stop you popping wheelies at a moments notice.

Too right I reckon you will need to wear a gum shield,cos that front end will be coming up [\quote]

We may need a new "toothless smilie" for Jan and anyone else doing this conversion.

[JanBros]

last post from 2010

anyway, it was still in my shed, and sadly as of today it is RIP
too much vibration kept me from going further with it, but as long as I didn't need the money, I kept it because I must have ridden a KX500 powered bike one day.

So I bought an almost complete '88 KX500 rolling frame (appart from 3 plastics) a month ago and today took the '87 engine out of the Kr frame. Total cost of the finished KX should be well below 2000 euro, and over here the cheapest you find are +/- 4000 euro, so I get to ride "The Beast" and make a good profit. All in all not a bad deal I recon

[Luders]

that will be a complete animal Jan

[KR-1R]

.
.
Fit a roller starter Jan, to save your ankle for retirement.

num num...
Yamaha Marine Jet 800 - parallel twin


V-twin that sucker for lower vibration?



SATARN was attempting something along these lines...

[JanBros]

rode the KX500 for the first time today.

only thing I can say is : this is the first motorcycle I've ridden that scares me