JB Weld query

nate · Post by **nate** » Sun Jun 08, 2008 7:28 pm

Hi all,

After the comments about difficulty getting hold of it... well I have bought some... but just want to make sure its the high temp stuff

Its black and red packet... just says J B Weld

600 degrees Farenheit... takes about 15 hours to go off

is this the pukka stuff or the cheap and nasty stuff??

Would rather get it right, than it letting go in my engine

P.S. flowed the cylinders and the top end of the crank today....

Next week will do the inlet side

Leewc · Post by **Leewc** » Sun Jun 08, 2008 9:25 pm

JB weld is very good stuff, machines nicely too. I would use it for engine mods etc.

mgtkr1 · Post by **mgtkr1** » Mon Jun 09, 2008 5:38 pm

this is the correct stuff. jb weld is the next best thing to the tuners favourite, devcon. at least thats what im led to believe. have used it without any problems so far and mj uses the stuff without a problem as far as i know.