Page 1 of 1
32mm carbs
Posted: Thu Aug 31, 2006 10:08 am
by col
will rgv 32mm carbs work on a kr1?
obviously gonna have to find rubbers but if i can will they work or do the rgv jobbies non starters?
Posted: Thu Aug 31, 2006 1:38 pm
by JanBros
I have a set, just tried to see if there is enough room and that is ok.
can't see why they shouldn't work. might take some time to set them up properly.
Posted: Fri Sep 01, 2006 3:18 pm
by col
i wasnt sure about all the extra nonsence they put on the rgv carbs, you know the air acutator stuff, whatever that does, i've no idea
carbs
Posted: Fri Sep 01, 2006 7:49 pm
by sprocket stu
my brother in law has just fitted a pair to a rd400 with good reults, as for the actuator set up all he did was blank off the extra pipes to prevent leaks.we are yet to have the bike out in anger but results in the garage are good up to now
Posted: Fri Sep 01, 2006 8:29 pm
by col
apparently yhe earleir models didnt have the actuator
Posted: Wed Sep 06, 2006 6:52 pm
by mj43
They are a bugger to set up. Colin Sleigh had a set working.
My advice is unless you can get the settings of Colin stick to PWKs they are a lot easier to work with.
Posted: Mon Oct 02, 2006 8:54 pm
by Bikemike
I've just spotted these on ebay,
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... %26fvi%3D1
Could this be the same Colin that Mark mentioned?
If so you've got half a chance of getting them working.
Mike
Posted: Tue Oct 03, 2006 7:50 am
by Garry
yes it is the same one - i bought quite a few bits off him in the past
doesn't seem to be registered on the new site yet - not sure if he knows
about it - have sent him a message