PWK Carbs - reassembling ??

spirit · Post by **spirit** » Wed Mar 23, 2011 12:37 am

I removed the float bowl to check the condition of the carb. Removing the float bowl was awkward - that angled tube fixed to the bottom of the bowl seemed to snag on the float and the main jet assembly.
And refitting the float bowl was very awkward - the angled pipe kept snagging on the parts .... Is it just me or is there a technique to removing and fitting the float bowl ?

Luders · Post by **Luders** » Wed Mar 23, 2011 12:42 am

No it's not just you, but I would not say it's awkward either, just a technique and something you get used to.

spirit · Post by **spirit** » Wed Mar 23, 2011 12:52 am

Luders wrote:No it's not just you, but I would not say it's awkward either, just a technique and something you get used to.

Thanks

.... I was afraid I was going to damage the float assembly - I'm sure it'll get easier with practice!

headcoats · Post by **headcoats** » Wed Mar 23, 2011 11:08 am

Holding carb upside down and once float bowl screws are removed,it 's a case of cocking the bowl to one side as you remove it

Bit of practice and you will be an expert