Exhaust Dents,how Do You Remove them !!

Luders · Post by **Luders** » Mon Nov 26, 2012 5:59 pm

Who did you speak to? I find it really hard to believe.

Post by **500bernie** » Mon Nov 26, 2012 6:31 pm

That is never a factory finish......

(When is a cone, not a cone - when it looks like a crushed coke can)

headcoats · Post by **headcoats** » Mon Nov 26, 2012 6:49 pm

http://www.jl-mxshop.com/yamaha-rz350-y ... -203-p.asp

Just found this on the site

If you look on the inners of the fattest section of the chambers then you can see the dents !!

maccas · Post by **maccas** » Mon Nov 26, 2012 6:54 pm

JL don't purge weld their stainless pipes either. I wasn't very happy about this when they cost as much as they do.

Dan

375 · Post by **375** » Mon Nov 26, 2012 7:18 pm

Yep can see the dent factory fresh, now do want gp pipes or not.

headcoats · Post by **headcoats** » Mon Nov 26, 2012 7:32 pm

375 wrote:Yep can see the dent factory fresh, now do want gp pipes or not.

Funny enough,yes i do

Can't see anything else but GP pipes on my Kenny build now
There's no going back